On Oct 20, 8:40*am, "Gott Lieb?" <r...@papinball.com> wrote:
> Good news! *Funny, I was going to suggest this opto board set to you.
> Are you using just common super bright red LEDs for this?
>
> Jim
>
> On Oct 19, 10:49*pm, "Tony @ GLM" <cl...@greatlakesmodular.com> wrote:
>
> > STN-LHBS : Long Hop Opto Board Set (transmitter and receiver)http://www..greatlakesmodular.com/pr...l/stnlhbs.html
> > (compatible with OEM#'s 520-5083-00 and 520-5082-00
>
> > --
>
> > Tonywww.greatlakesmodular.com-Re-Engineered Pinball Parts!
I wouldn't call the LEDs they used common. It's a super narrow angle
one, probably about 4-5 degrees per the Toshiba TLRH180P datasheet.
But that one isn't readily available, I'm using the closest match I
could find. You can probably use any of the wider angled variety, I
don't think the receiver circuit would care, but it is visible light I
was trying to keep the bleed over down to a minimum.
Curious if it would work with any color set...might be an option for
color coordinating games.
Tony
www.greatlakesmodular.com - Re-Engineered Pinball Parts!
Linear Mode
